The bullet feeder die is case activated which means the bullet will only feed upon contact with a case. The collets are made of solid steel and durable enough for years of reloading.

Lee's Pistol 4-Die Set includes Carbide Full Length Sizing Die, Bullet Seating Die, Powder Thru Expanding Die, Carbide Factory Crimp Die, Universal Shell Holder, Powder Dipper and instructions/load data.

Lee's Carbide Factory Crimp Die sizes the cartridge while being crimped so every round will positively chamber freely with factory like dependability. This die applies a roll style crimp. The adjusting screw quickly and easily sets the desired amount of crimp. Trim Length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered. A firm crimp is essential for dependable and accurate ammunition, as it eliminates the problems of poor ignition of slow burning magnum powders.

Lee 44 SPECIAL/44 MAG Taper Crimp Die, overcomes crimp problems caused by poor die design. Offers little or no advantage when used with 1986 or newer Lee Dies as the crimp angle is already a modified taper crimp.

Lee Pro 1000 progressive 3-hole reloading kit for 44 Special/44 Magnum. Includes press, dies (Carbide Full Length Size, Powder Through Expanding and Bullet Seating dies), 3-Hole Turret, #11 Shell Plate, Pro Auto Disk Powder Measure, Universal Case Feeder and priming system.

Grips the shell for a firm fit in the press during reloading or priming operations. Universal shell holder used in most brands of reloading presses. Not for use with the Auto-Prime.

Lee's Carbide 3-Die Set includes Carbide Full Length Sizing Die, Powder Thru Expanding Die, Universal Shell Holder, Powder Dipper and instructions/load data.